What's new in this version of our VFD spindle?
We worked with our spindle vendor to custom make a new spindle, incorporating years of feedback from users. The new spindle adds the following features:
- Now uses ER-16 collets, so you can use cutters with larger shanks.
- A 3/8" collet is included, in addition to the 1/8" and 1/4" collets that were previously included.
- The spindle body extends further toward the collet, making it work better with the standard Sweepy 65.
- New, removable wiring harness.
- New electronics and electronics enclosure.
- Upgraded to larger spindle bearings to increase durability.
- New heavy-duty connector.
Details:
- 65mm Air-cooled 1200W spindle
- Uses ER-16 collets
- Maximum cutter diameter: 3/8" / 10mm
- 110V, 12A draw
- 8k - 24k RPM
- RPM is fully controlled by your G-code
- VFD Enclosure with AC filtering built-in
- Adapter board for speed control from Carbide Motion
- Fully supported by Carbide 3D and Carbide Motion
Compatibility
The VFD controller cannot run on a GFCI (ground fault) outlet. If you have a GFCI outlet, the VFD will not function properly. This is not a limitation of our particular VFD, it is a limitation of all VFDs.
This VFD and spindle ONLY run on 110V, it is not compatible with 220V power.
This spindle is 65mm in diameter, so it should fit any Shapeoko 3, 4, Pro, or 5 Pro. That said, it is significantly heavier than a standard trim router, so we prefer to pair it up with an HDZ but the Z-Plus works well too. We do not recommend adding the VFD Spindle to the original Shapeoko 3 belt-drive Z-Axis.
This 65mm spindle is compatible with Sweepy 65 for dust collection.
