Solid Carbide Spektra™ Extreme Tool Life Coated Mortise Compression Spiral Router Bits feature unique, harder carbide with nACo® nanocomposite coating for longer tool lifetime.
These tools have a much shorter up-cut section than the standard compression tools. They are ideal for mortising grooving and dado. 3 Flute Design (on certain item #'s) provides an extra-smooth finish.
59434-K contains small chip breakers that break up the chips and allow the bit to run cooler and faster.
Special unique carbide grade increased clearance geometry and razor-sharp cutting edges with polished flutes provide a superior finish and longer tool life especially in abrasive materials. Great for production settings and excellent for creating grooves and dado cuts in particleboard plywood and laminate. Primarily used on CNC machines and other automatic routers. Can be used with handheld and table-mounted portable routers.
THE ONLY Spektra™ Coated Bits – Made in the USA 
Amana Tool® solid carbide router bits provide consistent, repeatable quality. Every tool is guaranteed to match the geometry on the prints, every time on every order. Best control of carbide grades for woodworking, and absolute control of quality standards on all carbide blanks.
Amana Tool Spektra™ bits feature a nACo® nanocomposite coating with an extreme nanohardness and heat resistance. With a brilliant, distinctively-tinted coloring, nACo provides additional improvements in four critical aspects of router tooling.
- nACo coating is an micro-thin ceramic coating which enables the tool's cutting edge to retain crucial sharpness and lubricity. This provides longevity and produces cutting results of the highest quality.
- Coatings prevents high heat and oxidation which is detrimental to cutting tool performance.
- Multi-colored hues, while attractive, will dissipate upon use and yet coating will remain fully effective.
- nACo offers approximately 4,500 Vickers for impressive solid hardness on cutting areas of the tool, for an increase up to 2.5 times compared to uncoated bits.
Excellent for Cutting:
- Cork
- Laminate & Melamine
- Laminated Plywood
- Melamine Particle Board
- Particle Board
- Softwood/Hardwood
- Veneered Plywood
- Wood
Note: Blue based color dissipates immediately upon use. nACo® nanocomposite coating will not wear off.
Recommended RPM 20,000-21,000.
WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.
How to Make Mallet on CNC | ToolsToday Video
